Skip to content
Winter Storm GearField guide
Guides menu67 guides

Power and heatHow-to4 sources

Charge Controllers for Backup Batteries: PWM or MPPT in an Outage

A charge controller lets a small solar panel recharge a 12 volt backup battery in a long outage. How PWM and MPPT differ and which settings matter in the cold.

We earn from qualifying purchases through links on this page.

Gray outdoor electrical boxes and black conduit pipes mounted on a brick wall

Quick reference4 facts

What it doesSits between a solar panel and a battery and controls how the battery charges
PWMEssentially a switch; low cost, suited to small systems (Victron)
MPPTCan harvest 10 to 40% more in cool weather; worth it above a few hundred watts (Victron)
Lithium in the coldVictron's low temperature cut-off defaults to 5°C (41°F) once enabled with a sensor
On this page (6 sections)
  1. Why does a backup battery need a charge controller?
  2. How do PWM and MPPT controllers differ?
  3. Which battery settings matter most?
  4. Can a lithium battery charge in freezing weather?
  5. Where should the battery and controller go?
  6. What does a simple outage setup look like?

A charge controller sits between a solar panel and a 12 volt battery and manages how the battery charges, so a small panel can top up a backup battery through a long outage. PWM controllers are simple and cheap. MPPT controllers cost more but pull more from the panel in cold weather. Set the controller to match your battery type.

Why does a backup battery need a charge controller?

A charge controller exists because a solar panel puts out more voltage than a battery should see, and the right amount changes as the battery fills. Without one, a panel can overcharge a battery and shorten its life. With one, the battery charges in stages: bulk (as much current as possible), absorption (held at a set voltage) and float (a lower holding voltage once full).

For an outage plan, the controller is what turns a 12 volt power inverter and a battery into something you can keep using for more than one evening. Charge the battery from the panel by day, run lights and chargers from the inverter at night.

Victron’s manual gives one sizing rule worth knowing before you buy panels: the panel’s voltage must be at least 5 volts higher than the battery voltage before the controller starts charging. Check the panel’s spec label against the controller manual before you match a panel to a battery bank.

How do PWM and MPPT controllers differ?

The two types solve the same problem in different ways. Victron’s comparison is the clearest summary:

Type How it works Fits
PWM Essentially a switch that connects the panel to the battery Small, low-cost setups; panel voltage close to battery voltage
MPPT Converts higher panel voltage down to battery voltage Larger panels or arrays; cold, bright days

Victron says an MPPT controller can harvest 10 to 40% more energy than PWM when cell temperatures are below 45°C, which describes most winter days. It adds that MPPT generally makes sense once the array passes a few hundred watts. For a single small panel and one battery, a PWM unit may be all you need.

PWM and MPPT charge controllers

Shop battery charge controllers

Opens eBay in a new tab. Check condition, seller feedback and returns.

Which battery settings matter most?

Charge voltages depend on the battery chemistry, and getting them wrong is the most common setup mistake. Victron’s defaults for 12 volt systems give a sense of the range:

  • Lead-acid (default profile). Absorption at 14.4 volts, float at 13.8 volts.
  • Lithium iron phosphate (LiFePO4). Absorption at 14.2 volts for a fixed 2 hours, with equalization turned off.

Victron also notes that LiFePO4 batteries “do not need to be fully charged to prevent premature failure,” unlike lead-acid batteries, which do better when brought to full charge regularly. Always use your battery maker’s figures where they differ from a controller’s defaults.

Equalization is a periodic high-voltage charge for some flooded lead-acid batteries. It is not for every battery. Victron’s manual is direct: “Do not equalize charge Gel, AGM, VRLA or lithium batteries.”

Thick snow and a row of icicles hanging from the edge of a roof after heavy snowfall
Snow on a panel stops charging; brush it off from the ground where you can, and keep off icy roofs.

Can a lithium battery charge in freezing weather?

Cold is the winter-specific problem. Many lithium iron phosphate batteries should not be charged below freezing, and an outage in a cold garage or shed can put them there. Victron controllers include a low temperature cut-off that stops charging when the battery gets too cold. It is off by default, needs a battery temperature reading from a sensor, and defaults to 5°C (41°F) once enabled. Some lithium batteries block cold charging on their own; check with your battery maker.

Lead-acid batteries handle cold charging better but lose capacity in the cold, so a battery kept somewhere warmer, and ventilated, gives more usable power.

Where should the battery and controller go?

The battery bank belongs in a spot that is dry, ventilated and protected from freezing where possible. Lead-acid batteries release hydrogen while charging, as Samlex’s inverter manual warns, so they need ventilation and distance from sparks and flames. Keep cable runs short and use the fuse sizes in the controller’s manual.

A solar setup is fuel-free, but many outage plans pair it with a generator or a car for cloudy stretches. Those bring carbon monoxide into the picture.

Carbon monoxide

If you top up batteries from a generator or a running car, keep it outdoors, more than 20 feet from windows, doors and vents. The CDC says never to use a generator in a home or garage, and never to run a car in a garage attached to a house, even with the door open. Read the carbon monoxide safety guide and keep battery-backed CO alarms near sleeping areas.

What does a simple outage setup look like?

A modest setup has four parts: a deep-cycle or lithium battery, a charge controller matched to it, one or two panels, and an inverter for AC devices. This is a small backup for lights, chargers and a radio, not a whole-house system. For whole-house loads, see home standby generators.

Check off the rest of your supplies with the winter power outage checklist.

Battery banks are one part of an outage plan; the rest is in our power outages section.

Frequently asked questions

Do I need a charge controller to charge a battery from a solar panel?

For anything beyond a tiny trickle panel, yes. The controller limits voltage so the battery charges in stages and is not overcharged. Victron's manuals set absorption and float voltages for each battery type for this reason.

Is PWM or MPPT better for a small backup battery?

Victron describes PWM as a low-cost option that is essentially a switch, suited to small systems. MPPT costs more but can harvest 10 to 40% more energy when panels are cool, and Victron says it makes sense once the panel array passes a few hundred watts.

Can I charge a lithium battery below freezing?

Many lithium iron phosphate batteries should not be charged in the cold. Victron controllers offer a low temperature cut-off, off by default, that needs a temperature sensor; its default setting is 5°C (41°F). Check your battery maker's limits.

Should I equalize my backup battery?

Only if the battery maker says to. Victron's manual says: Do not equalize charge Gel, AGM, VRLA or lithium batteries. Some flooded lead-acid batteries need periodic equalization.

Sources

  1. MPPT solar charger manual, SmartSolar MPPT 75/10 up to 100/20Victron Energy
  2. Which solar charge controller: PWM or MPPT?Victron Energy
  3. SAM Series Power Inverters Owner's ManualSamlex America
  4. Carbon Monoxide Poisoning BasicsCenters for Disease Control and Prevention

Filed under Power and heatPart of Winter Power Outages: Generators, CO Alarms and Food Safety

Affiliate disclosure

Winter Storm Gear is reader-supported. Some links on this page are affiliate links: when you buy through them, we may earn a commission at no extra cost to you. As an eBay Partner, we may be compensated if you make a purchase through our links. Commissions never decide what we recommend or how we rank it. Listings and prices come from our partners and change often, so check the price, condition and seller on the retailer's page before you buy. Read how we make money.